You must have atleast the UT3 patch 2 installed before you install RypelCam.
For RypelCam installation instructions pls see the included html-Tutorial.
The Tutorial includes everything you need to know to start with RypelCam.
THIS IS A BETA RELEASE! Keep an eye on rypelcam.net for updates
SOME OF THE MOST NOTICEABLE KNOWN PROBLEMS IN THIS BETA ARE:
- Cameracontrol in serversides doesent really work yet (this version is tweaked for clientside demos
which caused some problems in serverside demos, that will be fixed in an updated release)
- Vertical aim of 3rdperson Camera in clientside demos, affects the vertical aim of the demorecorders playermodel
More info and updates etc, aswell as a discussion board, can be found at
If the Tutorial doesent anwser one of your questions pls search the
rypelcam.net forum and IF YOU CANT FIND AN ANSWER THERE, PLS MAKE A NEW THREAD OR EMAIL ME YOUR PROBLEM/QUESTION.
Pls report any bugs if you want to get them fixed. I played UT six years ago, but today i only start UT if i work on RypelCam,
so if a new bug or compatibility issue appears i usually wont notice until someone tells me.
Changes from 3.05 to 3.04:
- improved "toggleMovieMode" consolecommand. It now also disables the Clock and the Armor/Armorguy display in the lower left.
(see Changes below about the new console commands introduced in 3.04)
Changes from 3.04 to 3.03:
- Added 2 new console commands:
- "seekTo x y z", where x stands for Minutes, 'y' for seconds and 'z' for the fastforward-speed you wish to use. Be aware that a value for 'z'
greater than 10 might cause the clock to lag. This can result in seekTo ending too early. Experiment a bit to find the greates value that still works good on your PC.
- "toggleMovieMode", use this command to toggle between full hud and minimal hud details in firstperson mode. Minimal hud-details usually look better in a fraggmovie.
Changes from 3.03 to 3.02:
- Addressed compatibility issues with Demos that were recorded on a server with UTComp.
- Note that RypelCam still wont work with Clientside demos that were recorded before UT3 Patch 2.0 even though UTComp already supported Clientside demos
before UT3 Patch 2.0 came out. This wont be fixed since RypelCam needs the extra functionality that was added in UT3 Patch 2.0 to work correctly.
Changes from 3.02 to 3.0 Beta 1:
- From this Version on, when installing RypelCam (see Tutorial for detailed install steps)
, you need to change the UTGame.ini entry for every new Release. For this Release it is "DecalManagerClassPath=RCam302.RCamDecalManager"
- Fixed: freecam movement in serverside demos
- Improved smootheness of Cams a bit
The RypelCam team currently consists of:
RypeL : mod programming
Gammo : website
Special thx to:
Azura
BronsoN
CaNaBiS
Checkmate
Dvion
Electry
Epitaph
fotty
Gammo
Green^mArine
Kronos
meep
orangY
w1z4
Wormbo
Zielbetrag
